Pre-Installing MS Products using the OEM Pre-Install Kit

1.You are a system builder. Your network uses a Microsoft Windows Server? 2003 that is running
the Dynamic Host Configuration Protocol (DHCP) service and is set up as a technician computer.
You installed OPKTools from Microsoft Windows? XP Service Pack 2. You want to set a static
Internet Protocol (IP) address for the Microsoft Windows Preinstallation Environment on the
computer that you are installing for your customer. During the preinstallation process, you
receive the following error message: Cannot Authenticate to Server. What should you do? (Each
correct answer presents part of the solution. Choose two.)
A.Edit the winbom.ini file in the WinPE.net section to include the Gateway= parameter.
B.Edit the winbom.ini file in the WinPE.net section to include the StartNet= parameter.
C.Edit the winbom.ini file in the WinPE.net section to include WinPEFirewall=On.
D.Edit the winbom.ini file in the WinPE.net section to include the IPConfig= parameter.
Correct:A D

2.You are a system builder. Your network is using a four-port router that is running the Dynamic
Host Configuration Protocol (DHCP) service. Your technician computer runs Microsoft Windows?
2000 Professional and is connected to the four-port router. You have installed a media reader card
in a computer, and you use OPKTools to preinstall this computer over the network. In Audit mode
you discover that the media card reader device has failed and that it is not enumerated in Device
Manager. You need to preinstall your computers with this card reader. What should you do? (Each
correct answer presents part of the solution. Choose two.)
A.Add the DriverSigningPolicy=Ignore parameter in the Unattended section of the unattend.txt answer file
to preinstall the unsigned driver.
B.Remove the incorrect driver that was installed.
C.Add the DriverSigningPolicy=Warn parameter in the Unattended section of the unattend.txt answer file.
D.Obtain an updated driver (if one exists) from the manufacturer.
E.Run sigverif.exe from a command prompt to verify that all the drivers are signed.
F.Add the DriverSigningPolicy=Block parameter in the Unattended section of the unattend.txt answer file.
Correct:A D